Does it matter according to the Cisco 200-105 dumps certification exam pattern? The Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0) (200-105 ICND2) exam is a 90 Minutes (45-55 questions) assessment in pass4itsure that is associated with the CCNA Routing & Switching certification. 100% pass rate Cisco 200-105 dumps ICND2 pdf practice exam questions video online. “Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0)” is the exam name of Pass4itsure Cisco 200-105 dumps test which designed to help candidates prepare for and pass the Cisco 200-105 exam. Cisco Certified Network Associative Routing & Switching certification validates your ability to Configure, verify, and troubleshoot VLANs (normal/extended range) spanning multiple switches, Configure and verify PPP and MLPPP on WAN interfaces using local authentication and Configure, verify, and troubleshoot VLANs (normal/extended range) spanning multiple switches. These https://www.pass4itsure.com/200-105.html dumps skills allow you to simplify and standardize the most complex daily activities running your team increase your credibility and value within the organization.
[100% Pass Rate Cisco 200-105 Dumps From Google Drive]: https://drive.google.com/open?id=0BwxjZr-ZDwwWWWw0QXQxY3R1X1E
[100% Pass Rate Cisco 200-355 Dumps From Google Drive]: https://drive.google.com/open?id=0BwxjZr-ZDwwWUkUwT0lYclNxbFU
Objectives of 200-105 Dumps Exam:
CCNA Routing & Switch 200-105 dumps ICND2 describe the following topics areas
- Configure, verify, and troubleshoot VLANs (normal/extended range) spanning multiple switches
- Describe the benefits of switch stacking and chassis aggregation
- Configure and verify PPP and MLPPP on WAN interfaces using local authentication
2018 Feb Pass4itsure Cisco 200-105 Dumps Actual Test(18-41)
Refer to the exhibit.
A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise, the routers are configured with their default configurations. A ping from Host1 to Host2 fails, but the technician is able to ping the S0/0 interface of R2 from Host1. The configurations of the hosts have been verified as correct. What is the cause of the problem?
A. The serial cable on R1 needs to be replaced.
B. The interfaces on R2 are not configured properly.
C. R1 has no route to the 192.168.1.128 network.
D. The IP addressing scheme has overlapping subnetworks.
E. The ip subnet-zero command must be configured on both routers.
200-105 exam Correct Answer: C
Whenever a node needs to send data to another node on a network, it must first know where to send it.
What are three benefits of GLBP? (Choose three.)
A. GLBP supports up to eight virtual forwarders per GLBP group.
B. GLBP supports clear text and MD5 password authentication between GLBP group members.
C. GLBP is an open source standardized protocol that can be used with multiple vendors.
D. GLBP supports up to 1024 virtual routers.
E. GLBP can load share traffic across a maximum of four routers.
F. GLBP elects two AVGs and two standby AVGs for redundancy.
Correct Answer: BDE
Load Sharing You can configure GLBP in such a way that traffic from LAN clients can be shared by multiple routers
Refer to the exhibit.
What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)
A. Router(config)# interface fastethernet 0/0 Router(config-if)# ip address 192.168.1.1 255.255.255.0 Router(config-if)# no shut down
B. Router(config)# interface fastethernet 0/0 Router(config-if)# no shut down Router(config)# interface fastethernet 0/0.1 Router(config-subif)# encapsulation dot1q 10 Router(config-subif)# ip address 192.168.10.1 255.255.255.0 Router(config)# interface fastethernet 0/0.2 Router(config-subif)# encapsulation dot1q 20 Router(config-subif)# ip address 192.168.20.1 255.255.255.0
C. Router(config)# router eigrp 100 Router(config-router)# network 192.168.10.0 Router(config-router)# network 192.168.20.0
D. Switch1(config)# vlan database Switch1(config-vlan)# vtp domain XYZ Switch1(config-vlan)# vtp server
E. Switch1(config)# interface fastethernet 0/1 Switch1(config-if)# switchport mode trunk
F. Switch1(config)# interface vlan 1 Switch1(config-if)# ip default-gateway 192.168.1.1
Correct Answer: BE
The two answers B and E list all the commands needed to configure interVLAN routing.
Which feature does PPP use to encapsulate multiple protocols?
200-105 dumps Correct Answer: A
PPP permits multiple network layer protocols to operate on the same communication link. For every network layer protocol used, a separate Network Control Protocol (NCP) is provided in order to encaps
Which two states are the port states when RSTP has converged? (Choose two.)
Correct Answer: AD
Which three statements about VTP features are true? (Choose three.)
A. VTP works at Layer 3 of the OSI model and requires that a management VLAN IP address be configured.
B. When properly configured, VTP minimizes VLAN misconfigurations and configuration inconsistencies.
C. When properly configured, VTP maintains VLAN configuration consistency and accelerates trunk link negotiation.
D. Each broadcast domain on a switch can have its own unique VTP domain.
E. VTP pruning is used to increase available bandwidth in trunk links.
F. To configure a switch to be part of two VTP domains, each domain must have its own passwords.
G. Client, server, and transparent are valid VTP modes.
200-105 pdf Correct Answer: BEG
Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has built-in security mechanisms?
D. Frame Relay
Correct Answer: B
High-Level Data Link Control (HDLC) – HDLC is the default encapsulation type on point-to- point, dedicated links, and circuit-switched connections. It is used typically when communicating betw
What is a valid HSRP virtual MAC address?
200-105 vce Correct Answer: C
Why is the Branch2 network 10.1 0.20.0/24 unable to communicate with the Server farm1 network 10.1 0.10.0/24 over the GRE tunnel?
A. The GRE tunnel destination is not configured on the R2 router.
B. The GRE tunnel destination is not configured on the Branch2 router.
C. The static route points to the tunnel0 interface that is misconfigured on the Branch2 router.
D. The static route points to the tunnel0 interface that is misconfigured on the R2 router.
Correct Answer: C
Refer to the exhibit.
Assume that all of the router interfaces are operational and configured correctly. How will router R2 be affected by the configuration of R1 that is shown in the exhibit?
A. Router R2 will not form a neighbor relationship with R1.
B. Router R2 will obtain a full routing table, including a default route, from R1.
C. R2 will obtain OSPF updates from R1, but will not obtain a default route from R1.
D. R2 will not have a route for the directly connected serial network, but all other directly connected networks will be present, as well as the two Ethernet networks connected to R1.
200-105 exam Correct Answer: A
At which layer of the OSI model is RSTP used to prevent loops?
B. data link
Correct Answer: B
Explanation: RSTP and STP operate on switches and are based on the exchange of Bridge Protocol Data Units (BPDUs) between switches.
R1 is configured with the default configuration of OSPF. From the following list of IP addresses configured on R1, which address will the OSPF process select as the router ID?
200-105 dumps Correct Answer: A
The Router ID (RID) is an IP address used to identify the router and is chosen using the following sequence: + The highest IP address assigned to a loopback (logical
Which statement about the router configurations is correct?
A. PPP PAP is authentication configured between Branch2 and R1.
B. Tunnel keepalives are not configured for the tunnel0 interface on Branch2 and R2.
C. The Branch2 LAN network 192.168.11 0/24 is not advertised into the EIGRP network.
D. The Branch3 LAW network 192.168.10.0/24 is not advertised into the EIGRP network.
E. PPP CHAP is authentication configured between Branch1 and R1.
Correct Answer: D
You enter the show ipv6 route command on an OSPF device and the device displays a route. Which conclusion can you draw about the environment?
A. OSPF is distributing IPv6 routes to BGP.
B. The router is designated as an ABR.
C. The router is designated as totally stubby.
D. OSPFv3 is in use.
200-105 pdf Correct Answer: A
Refer to the exhibit.
Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)
A. The cable that is connected to S0/0 on RouterA is faulty.
B. Interface S0/0 on RouterB is administratively down.
C. Interface S0/0 on RouterA is configured with an incorrect subnet mask.
D. The IP address that is configured on S0/0 of RouterB is not in the correct subnet.
E. Interface S0/0 on RouterA is not receiving a clock signal from the CSU/DSU.
F. The encapsulation that is configured on S0/0 of RouterB does not match the encapsulation that is configured on S0/0 of RouterA.
Correct Answer: EF
When a router undergoes the exchange protocol within OSPF, in what order does it pass through each state?
A. exstart state andgt; loading state andgt; exchange state andgt; full state
B. exstart state andgt; exchange state andgt; loading state andgt; full state
C. exstart state andgt; full state andgt; loading state andgt; exchange state
D. loading state andgt; exchange state andgt; full state andgt; exstart state
200-105 vce Correct Answer: B
OSPF states for adjacency formation are (in order) Down, Init, Attempt, 2-way, Exstart, Exchange, Loading and Full.
Why Are OSPF Neighbors Stuck in Exstart/Exchange State?
QUESTION 34 The image below is a view of the Sniffer Summary window. How many application turns are shown?
D. Can not be determined based on the information shown
QUESTION 35 Which of the following statements is true regarding the Real-time Transport Protocol?
A. Used by several protocols to provide end-to-end transmission of real-time data
B. Uses a proxy agent for client-server communications
C. Operates as a client-server protocol
D. Keep-alive messages provide status information
200-105 exam Answer: A
QUESTION 36 When capturing data in a multi-tier environment, attach the Sniffer to the application server using. (Choose all that apply)
A. A full duplex interface
B. A tap on the server connection
C. A mirror on the server switch port
D. A mirror on the database switch port
E. Two Sniffer network analyzers
QUESTION 37 The well-known port used by FTP servers to establish a Data connection is:
200-105 dumps Answer: C
QUESTION 38 The slowest component on a server will be .
A. Random Access Memory (RAM)
B. Disk I/O
C. Central Processing Unit (CPU)
D. The constraint (bottleneck)
QUESTION 39 When using Application Intelligence to isolate traffic distribution we should focus on .
B. Number of packets
C. Total number of bytes
D. All of the above
200-105 pdf Answer: D
QUESTION 40 Which of the following may contribute to poor application performance? (Choose all that apply)
A. Client processing of incoming requests
B. Server processing of incoming requests
C. Queuing of frames on an intermediate router
D. Efficient use of TCP/IP protocols
E. Inefficient configuration of TCP
QUESTION 41 The type of application usually does not have any request/reply interactions after the initial session is established.
200-105 vce Answer: D
See What Our Customers Are Saying:
We at Pass4itsure are committed to our customer’s success. There are 50,000+ customers who used this preparation material for the preparation of various certification exams and this number of customers is enough for new candidates to trust in these products. Our Cisco 200-105 dumps are created with utmost care and professionalism. We utilize the experience and knowledge of a team of industry professionals from leading organizations all over the world.
Pass4itsure provide the Cisco 200-105 dumps exam preparation materials in two different methods, Practice Test Software and PDF Format. The PDF format ensures portability across a number of devices to allow for preparation on the go. “Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0)”, also known as 200-105 exam, is a Cisco certification which covers all the knowledge points of the real Cisco exam. Pass4itsure Cisco 200-105 dumps exam questions answers are updated (204 Q&As) are verified by experts. The associated certifications of 200-105 dumps is CCNA Routing & Switching. For a more difficult and more complete Cisco Certified Network Associative Routing & Switching https://www.pass4itsure.com/200-105.html dumps exam preparation practice test software simulates the environment of the real 200-105 exam.
Read More Youtube: https://youtu.be/ZeAu5mz1CUw
Compared with other brands, Pass4itsure has up to dated exam information, affordable price, instant exam PDF files downloaded, error correction, unlimited install,etc. Such as
Pass4itsure 100% Pass Rate Cisco 200-105 Dumps Practice Exam, Real Cisco 200-105 Dumps Questions Online, We Help You Pass Interconnecting Cisco Networking Devices Part 2.Simple and Easy! To take advantage of the guarantee, simply contact Customer Support, requesting the exam you would like to claim. Pass4itsure guarantee insures your success otherwise get your MONEYBACK!